Edelbrock 2166 User Manual download pdf (Page 4)

Catalog #2166, #3766, #7166, #7566

Rev. 3/05 - RS/mc

Brochure #63-0296Page 4 of 4

INSTALLATION INSTRUCTIONS

1) Use only recommended intake gaskets set when installing

this intake manifold. For ease of installation, we

recommend Edelbrock Intake Manifold Bolt & Washer Kit

#8569.

2) Fully clean the cylinder head intake flanges and the engine

block end seal surfaces.

3) Apply Edelbrock Gasgacinch sealant P/N 9300 to both

cylinder head flanges and to the cylinder head side of the

gaskets, allow to air dry, and attach the intake gaskets.

Figure 1 - 429/460 Ford Torque Sequence

Torque Bolts to 25 ft/lbs.

Firing Order: 1-5-4-2-6-3-7-8

Turn Distributor Clockwise to Advance Ignition Timing

4 1416 8 2

8765

421 3

4) Do not use cork or rubber end seals. Use RTV silicone

sealer instead. Apply a ¼" high bead across each block

end seal surface, overlapping the intake gasket at the four

corners. This method will eliminate end seal slippage.

5) Install the intake manifold and hold-down bolts. Torque all

of the manifold bolts in two steps by the sequence shown

in Figure 1 to 25 ft/lbs.

10 12 6

Edelbrock Corporation • 2700 California St. • Torrance, CA 90503

Tech Line: 800-416-8628 • E-Mail: [email protected]

EGR Adapter Plate

(Supplied)

EGR Adapter Gasket

(Supplied)

Intake Manifold

Front

Figure 2 - EGR Adapter Plate Installation (3766 Intake Manifold)

Install OEM EGR Spacer and Gasket on Top of Edelbrock Adapter Plate

1 2 3 4

No comments

Edelbrock 2166 User Manual Page 4